The Light ConversionFLINT oscillator is based on Yb:KGW crystal end-pumping by high brightness laser diode module. Generation of femtosecond pulses is provided by Kerr lens mode-locking, once started, modelocking remains stable over a long period of time and is immune to minor mechanical impact. The oscillator can be equipped with external electrooptical Pulse Picker and appropriate timing electronics allowing selection of a single pulse at repetition rates up to 100 kHz. Piezo-actuator can be implemented in customized oscillators in order to control the cavity length. FLINT oscillator can also be equipped with Carrier Envelope Phase (CEP) stabilization system.

LOCKING OF THE OPTICAL PULSE TO AN EXTERNAL SIGNAL

Pharos oscillator can be equipped with piezo actuators for precise control of the cavity length.

CARRIER ENVELOPE PHASE (CEP) STABILIZATION

Pharos oscillator can be equipped with nonlinear interfero­meter and feedback loop throughout the pump current of the laser diode bar for CEP stabilization. The figure on the right shows typical measurement of power spectrum density and integrated CEP phase error. The integrated phase error is in the frequency range from 50 Hz to 10 MHz is <70 mrad (in loop measurement).

Features

  • Sub‑80 fs without any additional pulse compressor
  • 125 nJ maximum pulse energy
  • 10 W output power
  • 76 MHz is standard
  • Practically no amplified spontaneous emission
  • Rugged, industrial grade mechanical design
  • Automated harmonic generator (515 nm)
  • Optional CEP stabilization
  • Possibility to lock to external clock

Download datasheet here.

MODEL Flint 1.0 Flint 2.0 Flint 4.0 Flint 6.0 Flint 10 Flint SP
Max. average power >1W >2W >4W >6W >10W1) >600mW
Pulse duration (assuming Gaussian pulse shape) <80fs <100fs <120fs <40fs
Pulse energy >12nJ >25nJ >50nJ >75nJ >125nJ >7nJ
Repetition rate 76± 0.5MHz2)
Centre wavelength 1035± 10nm3)
Output pulse‑to‑pulse stability <0.5% rms over 24 hours3)
Polarization Linear, horizontal
Beam pointing stability <10µrad/°C
Beam quality TEM00; M2<1.2
Optional 2H generator >30% conversion efficiency at 517nm

1)Higher powers are available. Please contact Light Conversion for more information.

2)Other repetition rates are available in the range from 64MHz to 84MHz.

3)The center wavelength can be specified with tolerance ±2nm for customized oscillators.

4)With power lock on under stable environment.

Lasers & other Sources